The table shows the pin configuration of the Arduino UNO–based robotic arm. The red (VCC) wires of all servos are connected ...

Here's the new description with all links and additional text removed: Order your pcb design at JLCPCB: $2 for 10pcs PCBs (24 ...

Here’s something fun from [Chad Kapper] over on HackMakeMod: Escape Room Lockbox with the Cheap Yellow Display. You may have heard of the “cheap yellow display” (CYD), so-called due to the board’s ...

If you wanted to build a robot that chased light, you might start thinking about Raspberry Pis, cameras, and off-the-shelf computer vision systems. However, it needn’t be so complex. [Ed] of ...

ACEBOTT QD023 is an ESP32-based wearable gesture control glove that tracks finger movements with potentiometers instead of more traditional flex sensors.

The DR44 is a two wire Alternator with a built-in regulator. Well, really three wire but the third wire is not needed if adapting this alternator into another vehicle. The DR44 needs a 5V, 128Hz PWM ...

I2C_PWM_generator is a sketch to change an Arduino UNO in an I2C slave device to control the 6 PWM outputs of the Arduino UNO. One can think of this sketch as a co-processor that handles the 6 PWM ...

Abstract: This paper presents a two-segment motor system powered by two inverters with phase-shift pulsewidth modulation (PWM) to fulfill the purpose of low-torque ripple and vibration noise.

Abstract: The three-level Vienna rectifier is an attractive topology for power factor correction applications. However, for practical high-frequency applications, the nonlinearity caused by snubber ...